04-29-2010, 02:59 PM
Hi all. Since I am more a designer than a player I've been in the editor and have found a few things.
1. When using the first set of gray marble tiles on level 6 as I was moving some tiles I noticed that there were some graphic issues with trying to replace a tile. I would lose part on the tile, usually the upper right main part of the tile. This resulted in a sort of sawtooth pattern instead of a smooth surface.
2. Jack hiccup, when starting up a room in the test mode on Jack's first jump there is a noticeable delay in his reaction. Other items on the screen continue to move and after the first hiccup he reacts correctly. This also happens after he dies, the first jump has this delay.
3. Don't know if this is by design but clouds mountains and some other sprites seem to be limited to layer 0. Would be nice if these sprites could be set to be on the level where they're created. i.e. a cloud on layer 6 would be in front of rope/vine on layer 4.
4. This is a wish list thing and I understand how difficult it probably is (I believe I know what Vern is programming in as I have seen him on the boards for that tool) but it would be nice if there was a layer that moved so clouds could move and minor parallax effects could be enabled. Again, just a
Joe B
1. When using the first set of gray marble tiles on level 6 as I was moving some tiles I noticed that there were some graphic issues with trying to replace a tile. I would lose part on the tile, usually the upper right main part of the tile. This resulted in a sort of sawtooth pattern instead of a smooth surface.
2. Jack hiccup, when starting up a room in the test mode on Jack's first jump there is a noticeable delay in his reaction. Other items on the screen continue to move and after the first hiccup he reacts correctly. This also happens after he dies, the first jump has this delay.
3. Don't know if this is by design but clouds mountains and some other sprites seem to be limited to layer 0. Would be nice if these sprites could be set to be on the level where they're created. i.e. a cloud on layer 6 would be in front of rope/vine on layer 4.
4. This is a wish list thing and I understand how difficult it probably is (I believe I know what Vern is programming in as I have seen him on the boards for that tool) but it would be nice if there was a layer that moved so clouds could move and minor parallax effects could be enabled. Again, just a
would be nicething.
Joe B